Voyetra Turtle Beach Montego II Spécifications télécharger pdf (Page 55)

4-7

Installing the Avid Board Set

Before You Start the Installation

If you did not install memory, before you start the installation of the

Avid boards, you must make sure of the following:

• The system was turned off in a proper manner.

• The power cord is removed from the rear of the system.

•You read the User Guide IntelliStation M Pro Type 6868 Professional

Workstation for instructions that explain how to open the system

and install the PCI boards.

• You use a proper antistatic grounding wrist strap during the

installation.

• You know the revision levels of the software and hardware (see

the release notes for your Avid Xpress system).

• You determine the display controller board you have for use

during the driver installation section of this guide.

• You determine the slot locations of each board for your system

(see “Avid Xpress Board Configurations” on page 4-5).

The following sections are placed in the order that you might want to remove

and install boards. In general, you should start putting boards in at PCI slot

5 (if you have disk controller boards) and work your way up the PCI slot

numbers.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 115 116

Pas de commentaire

Voyetra Turtle Beach Montego II Spécifications Page 55